If the wires break, you should avoid soldering them:
Posted: Sun Feb 16, 2025 10:36 am
The most common breakdowns of IR heaters are the failure of the heating element and thermostat. Malfunctions are eliminated by replacing burnt-out parts. To correctly select the required part, you need to remove it, write down the number and order it online, or contact a repair service.
A burnt-out lamp (in most cases it looks like a tube, length – 30 cm, diameter – 10 mm) of the heating element can be replaced independently. Replacement work begins with disconnecting the device from the power supply. Then, on the section of the heater where the temperature controller is located, the side panel is removed, behind which there is a power vietnam telegram data connector for the lamp. We disconnect it, remove the tube. The lamps differ from each other only in power and size, and they are powered in the standard order – from 220 V. Therefore, there should be no difficulties with selection. Assembly after replacing the lamp is carried out in the reverse order.
If the thermostat burns out, the simplest solution is to short-circuit it, and the adjustment will be carried out through a 2 kW triac regulator. This will save time on searching and purchasing the part. under the influence of high temperature, the solder can melt. It is much more effective and safer to use a screw connection of wires. You may also find the information on connecting the thermostat useful.
Heaters have become an integral part of modern life, so issues related to their installation, operation and repair are of concern to many. Today, repairing an oil heater with your own hands and restoring the functionality of other types of these devices is a very common occurrence. This is due to the low quality of equipment offered on the current market, violation of operating rules and a number of other factors. In general, repairing a faulty heater is quite easy. The main thing is to be well versed in the types of heaters, know their features and have the skills to work with a certain tool.
A burnt-out lamp (in most cases it looks like a tube, length – 30 cm, diameter – 10 mm) of the heating element can be replaced independently. Replacement work begins with disconnecting the device from the power supply. Then, on the section of the heater where the temperature controller is located, the side panel is removed, behind which there is a power vietnam telegram data connector for the lamp. We disconnect it, remove the tube. The lamps differ from each other only in power and size, and they are powered in the standard order – from 220 V. Therefore, there should be no difficulties with selection. Assembly after replacing the lamp is carried out in the reverse order.
If the thermostat burns out, the simplest solution is to short-circuit it, and the adjustment will be carried out through a 2 kW triac regulator. This will save time on searching and purchasing the part. under the influence of high temperature, the solder can melt. It is much more effective and safer to use a screw connection of wires. You may also find the information on connecting the thermostat useful.
Heaters have become an integral part of modern life, so issues related to their installation, operation and repair are of concern to many. Today, repairing an oil heater with your own hands and restoring the functionality of other types of these devices is a very common occurrence. This is due to the low quality of equipment offered on the current market, violation of operating rules and a number of other factors. In general, repairing a faulty heater is quite easy. The main thing is to be well versed in the types of heaters, know their features and have the skills to work with a certain tool.